1. Specifications and other information of the Antminer Z9 mini are as mentioned below.

   Hashing algorithm: Equihash

    Power consumption: 300W

    Hashrate: 10k Sol/s ± 5%

   These are the conservative estimates. We expect the miners to deliver higher performance and efficiency when they are ready to ship.

2. We are currently accepting pre-orders for the Z9 mini. You can place an order by paying 50% of the order amount as down payment. Please note that the outstanding amount must be paid by the end of 1st August 2018 Beijing time(GMT+8).  Kindly note that as this is a preorder, the 50% down payment will be forfeited if you do not complete the payment by 1st August 2018 Beijing time(GMT+8). Please consider carefully before submitting your orders. 

3. There are financial risks associated with mining cryptocurrencies. These risks can be related to changes in exchange rate of the cryptocurrency or to changes in the algorithm that is used to mine the cryptocurrency. We would like to reiterate that you should consider carefully before making a purchase because requests for refund or order cancellation will not be entertained for any orders in this batch. 

4. Please select the correct address for shipping before you submit your order because the address cannot be changed after the order has been submitted.

5. The shipping for this batch will start on a first-paid-first ship basis on 24th August 2018 for orders that Bitmain has received full payment for. If the miners are ready before the estimated shipping date, we will ship it out ahead of the schedule. We recommend that you research and prepare in advance for customs' clearance in your country to avoid delays or unexpected costs.

6. You will need an ATX PSU with sufficient 4 six-pin PCIe connectors. All PCIe connectors on a hashing board need to be connected to the PSU for the hashing board to operate.  Bitmain recommends the APW3++ to power the Antminer Z9 mini.

7. Separate power supply to control board: there is one additional 6pin PCI-e connector on the IO board which must be connected to the PSU to get power. Be sure to power on the miner only after all the 3 PCIE connectors are connected to power supply.

8. The to be shipped products may have a different industrial design than the photo here.